Honda Integra DA6.
The procedure to extract the fault codes is. Jump the two wires in the connector. Turn ignition on the check engine light should be on and will flash the appropriate error code if there is a problem with the car.A long flash means 10 a short flash means 1
3 MAP Unplugged
6 ECT Unplugged
7 TPS Unplugged
The problems under the bonnet were the MAP, ECT and TPS were all unplugged.
We plugged all the connectors back in and the engine ran properly again.
To clear the codes we disconnected the battery.
There were no codes in the ECU any more.
The car wouldn't idle with the MAP, ECT and TPS unplugged.
The other tests you should do depends on what problem the car is having. Checking the fault codes will tell you the problem then you can replace or check the circuit that was displayed with a error code.
No comments:
Post a Comment